The Smart Coop Advanced Configurator - Program Your Automatic Door

Advanced configurator utility for The Smart Coop automatic door. Program automated opening and closing schedules based on sunrise and sunset, custom timers, or GPS location with precision control. Perfect for advanced users who want granular control over their automatic door settings.

Advanced Configuration Options

Light Sensor Mode: Automatically open after sunrise and close after sunset using the built-in light sensor
Timer Mode: Set specific opening and closing times with minute-level precision
GPS Mode: Calculate precise sunrise and sunset times based on your exact geographic location
Advanced Settings: Fine-tune opening and closing delays, enable extra safety features, adjust power modes, and customize door behavior
Manual Control: Option to manually control the door with the test button for complete flexibility

How The Advanced Configurator Works

Use this advanced configurator to program The Smart Coop automatic door with precision control. Select your preferred opening and closing options, adjust advanced settings to match your specific needs, and then follow the programming instructions to transfer your configuration to the door controller. The visual programming system uses screen flashing to communicate with your device.

OPENING OPTION

Open After Sunrise

Light Sensor

Open after sunrise.

Timer

Select this option to set specific opening time.

Do not open

Press the test button each time you want the door to open.

CLOSING OPTION

Close After Sunset

Light Sensor

Close after sunset.

Timer

Select this option to set specific closing time.

Do not close

Press the test button each time you want the door to close.

ADVANCED SETTINGS

Opening delay

Set closing morning delay.

20min

delay

Closing delay

Set evening closing delay.

20min

delay

Extra safety

Set to pause while closing for 20 seconds.

Full power mode

Close and open doors without obstacle sensor.

GPS MODE

Calculate sunrise and sunset based on your location and time. It' overrides light sensor.

HOW TO PROGRAM THE DOOR

PROGRAM THE DOOR

*Photosensitive warning, the screen will start flashing to program the door.